Dell PowerEdge R250 EMC Installation and Service Manual - Page 79

Installing the right control panel

Get Dell PowerEdge R250 PDF manuals and user guides View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 79 highlights

3. Remove the front bezel. 4. Remove the air shroud. Steps 1. Disconnect the control panel cable from the system board connector. NOTE: Observe the routing of the cable as you remove it from the system. 2. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly. 3. Hold the right control panel assembly and remove the control panel along with the cable from the system. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Figure 76. Removing the right control panel Next steps Replace the right control panel. Installing the right control panel Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the front bezel. 4. Remove the air shroud. Steps 1. Route the control panel cable through the side wall of the system and slide the cable into the clip. Installing and removing system components 79

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
3.
Remove the front bezel
.
4.
Remove the air shroud
.
Steps
1.
Disconnect the control panel cable from the system board connector.
NOTE:
Observe the routing of the cable as you remove it from the system.
2.
Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
3.
Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 76. Removing the right control panel
Next steps
Replace the right control panel
.
Installing the right control panel
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Remove the front bezel
.
4.
Remove the air shroud
.
Steps
1.
Route the control panel cable through the side wall of the system and slide the cable into the clip.
Installing and removing system components
79