Dell PowerEdge R250 EMC Installation and Service Manual - Page 58
Installing an expansion card into the expansion card riser, Next steps, Prerequisites
View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Figure 53. Removing an expansion card from the Riser 2. Install a filler bracket if the expansion card is not being replaced. Close the card retention latch. NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Figure 54. Installing filler bracket in the Riser Next steps If applicable, install an expansion card into the expansion card riser. Installing an expansion card into the expansion card riser Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 58 Installing and removing system components