Dell PowerEdge R250 EMC Installation and Service Manual - Page 62
Installing the Micro-SD card, Steps, Next steps, Prerequisites, Internal SD Card Port
![]() |
View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
4. Remove the IDSDM module. Steps 1. Locate the Micro-SD card slot on the IDSDM module, and press the card to partially release it from the slot. For more information about the slot location, see System board jumpers and connectors section. 2. Hold the Micro-SD card and remove it from the slot. NOTE: Temporarily label each Micro-SD card with its corresponding slot number after removal. Figure 59. Removing the Micro-SD card Next steps Replace the MicroSD cards. Installing the Micro-SD card Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. NOTE: To use a Micro-SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup. NOTE: Ensure that you install the Micro-SD cards into the same slots based on the labels you had marked on the cards during removal. Steps 1. Locate the Micro-SD card slot on the IDSDM module. Orient the Micro-SD card appropriately and insert the contact-pin end of the card into the slot. To locate IDSDM, see the System board jumpers and connectors section. NOTE: The slot is keyed to ensure correct insertion of the card. 2. Press the card into the slot to lock it into place. 62 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r250-emc-installation-service-manual-5f691d2/62.png)