Dell PowerEdge R250 EMC Installation and Service Manual - Page 41

Installing the drive into the drive carrier

Get Dell PowerEdge R250 PDF manuals and user guides View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

Figure 32. Removing the drive from the drive carrier Next steps Install the drive into the drive carrier. Installing the drive into the drive carrier Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs. Steps 1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier. 2. Align the screw holes on the drive with the screws holes on the drive carrier. 3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws. NOTE: If the drive or SSD carrier has Torx screw screwdriver to install the drive. , use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) Installing and removing system components 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Figure 32. Removing the drive from the drive carrier
Next steps
Install the drive into the drive carrier
.
Installing the drive into the drive carrier
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1.
Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2.
Align the screw holes on the drive with the screws holes on the drive carrier.
3.
Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE:
If the drive or SSD carrier has Torx screw
, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to install the drive.
Installing and removing system components
41