Dell PowerEdge R250 EMC Installation and Service Manual - Page 64
Installing the M.2 SSD module, Removing the M.2 SSD from BOSS S1 card carrier
View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Figure 61. Removing the M.2 SSD from BOSS S1 card carrier Next steps 1. Replace the M.2 SSD into the BOSS S1 card module. Installing the M.2 SSD module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the air shroud. NOTE: The procedure to install the BOSS S1 card is similar to the removing an expansion card. Steps 1. Align the M.2 SSD module at an angle with the BOSS S1 card connector. 2. Insert the M.2 SSD module until it is firmly seated in the BOSS S1 card connector. 3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS S1 card with the screw. 64 Installing and removing system components
Figure 61. Removing the M.2 SSD from BOSS S1 card carrier
Next steps
1.
Replace the M.2 SSD into the BOSS S1 card module.
Installing the M.2 SSD module
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Remove the
air shroud.
NOTE:
The procedure to install the BOSS S1 card is similar to the removing an expansion card.
Steps
1.
Align the M.2 SSD module at an angle with the BOSS S1 card connector.
2.
Insert the M.2 SSD module until it is firmly seated in the BOSS S1 card connector.
3.
Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS S1 card with the screw.
64
Installing and removing system components