Dell PowerEdge R250 EMC Installation and Service Manual - Page 53

Expansion cards and expansion card risers

Get Dell PowerEdge R250 PDF manuals and user guides View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Figure 47. Installing the heat sink Next steps 1. Follow the procedure listed in After working inside your system. 2. While booting, press F2 to enter System Setup and check that the processor information matches the new system configuration. 3. Run the system diagnostics to verify that the new processor operates correctly. Expansion cards and expansion card risers NOTE: When an expansion card is not supported or missing, riser the iDRAC and Lifecycle Controller logs an event. This does not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals. Installing and removing system components 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Figure 47. Installing the heat sink
Next steps
1.
Follow the procedure listed in
After working inside your system
.
2.
While booting, press F2 to enter System Setup and check that the processor information matches the new system
configuration.
3.
Run the system diagnostics to verify that the new processor operates correctly.
Expansion cards and expansion card risers
NOTE:
When an expansion card is not supported or missing, riser the iDRAC and Lifecycle Controller logs an event. This
does not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see
Troubleshooting
expansion cards
section in the
Dell EMC PowerEdge Servers Troubleshooting Guide
at
www.dell.com/poweredgemanuals
.
Installing and removing system components
53