Dell PowerEdge R250 EMC Installation and Service Manual - Page 32

Installing the intrusion switch

Get Dell PowerEdge R250 PDF manuals and user guides View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Figure 21. Removing the intrusion switch module Next steps Replace the intrusion switch module. Installing the intrusion switch Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the air shroud. Steps 1. Align and insert the intrusion switch module into the slot on the system until firmly seated. 2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module. 3. Connect the intrusion switch cable to the connector on the system board. NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped. 32 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Figure 21. Removing the intrusion switch module
Next steps
Replace the intrusion switch module
.
Installing the intrusion switch
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
Remove the air shroud
.
Steps
1.
Align and insert the intrusion switch module into the slot on the system until firmly seated.
2.
Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3.
Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
32
Installing and removing system components