Dell PowerEdge R250 EMC Installation and Service Manual - Page 63

Optional BOSS S1 card, Removing the M.2 SSD module

Page 63 highlights

Figure 60. Installing the Micro-SD card Next steps 1. Install the IDSDM module. 2. Install the air shroud. 3. Follow the procedure listed in the After working inside the system. Optional BOSS S1 card Removing the M.2 SSD module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the air shroud. 4. Remove the expansion card riser. 5. Remove the BOSS S1 card from the expansion card riser. NOTE: The procedure to remove the BOSS S1 card is similar to removing an expansion card. Steps 1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS S1 card. 2. Pull the M.2 SSD module to disconnect from the BOSS card connector. Installing and removing system components 63

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90

Figure 60. Installing the Micro-SD card
Next steps
1.
Install the IDSDM module
.
2.
Install the air shroud
.
3.
Follow the procedure listed in the
After working inside the system
.
Optional BOSS S1 card
Removing the M.2 SSD module
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Remove the
air shroud.
4.
Remove the
expansion card riser
.
5.
Remove the BOSS S1 card from the expansion card riser.
NOTE:
The procedure to remove the BOSS S1 card is similar to removing an expansion card.
Steps
1.
Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS S1 card.
2.
Pull the M.2 SSD module to disconnect from the BOSS card connector.
Installing and removing system components
63