Dell PowerEdge R250 EMC Installation and Service Manual - Page 31
Intrusion switch, Removing the intrusion switch module
![]() |
View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Figure 20. Installing a cooling fan Next steps 1. Install the air shroud. 2. Follow the procedure listed in After working inside your system. Intrusion switch This is a service technician replaceable part only. Removing the intrusion switch module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the air shroud. Steps 1. Disconnect and remove the intrusion switch cable from the connector on the system board. Observe the routing of the cable as you remove it from the system. 2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module. 3. Lift the intrusion switch module out of the system. Installing and removing system components 31
![](/manual_guide/products/dell-poweredge-r250-emc-installation-service-manual-5f691d2/31.png)