Dell PowerEdge R250 EMC Installation and Service Manual - Page 74
Next steps
![]() |
View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Steps 1. Unpack the new system board assembly. CAUTION: Do not lift the system board by holding a memory module, processor, or other components. CAUTION: Take care not to damage the system identification button while placing the system board into the chassis. 2. Lower the system board at an angle into the system, as shown in the image. 3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots. Figure 72. Installing the system board 4. Tighten all the screws and ensure the system board is firmly seated. Next steps 1. Replace the following components: a. Trusted Platform Module (TPM) NOTE: The TPM Module must be replaced only while installing new system board. b. IDSDM module (if installed) c. Internal USB key (if installed) d. Intrusion switch e. Expansion cards f. Expansion card risers g. Cooling fans h. Processor i. Heat sink j. Memory modules k. Air shroud l. System cover 2. Reconnect all cables to the system board. NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing bracket. 74 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r250-emc-installation-service-manual-5f691d2/74.png)