Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 123

Parameters Default Command Mode Usage Information Example None Enabled CONFIGURATION This command enables LLDP globally for all Ethernet (PHY) interfaces, except on those interfaces where LLDP is manually disabled. The no version of this command disables LLDP globally irrespective of whether LLDP is manually enabled on an interface. OS10(config)# lldp enable Supported Releases 10.3.1E or later lldp holdtime-multiplier Configures the multiplier value for the hold time (in seconds). Syntax lldp holdtime-multiplier integer Parameters integer - Enter the holdtime-multiplier value in seconds (2 to 10). Default 4 seconds Command Mode CONFIGURATION Usage Information Hold time is the amount of time (in seconds) that a receiving system waits to hold the information before discarding it. Formula: Hold Time = (Updated Frequency Interval) X (Hold Time Multiplier). The no version of this command resets the value to the default. Example OS10(config)# lldp holdtime-multiplier 2 Supported Releases 10.2.0E or later lldp med fast-start-repeat-count Configures the number of packets sent during the activation of the fast start mechanism. Syntax lldp-med fast-start-repeat-count number Parameters number - Enter the number of packets sent during the activation of the fast start mechanism (1 to 10). Default 3 Command Mode CONFIGURATION Usage Information None Example OS10(config)# lldp med fast-start-repeat-count 5 Supported Releases 10.2.0E or later lldp med Enables or disables LLDP-MED on an interface. Syntax lldp med {enable | disable} Layer 2 123