Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 337
ip name-server, show hosts
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 337 highlights
Default Command Mode Usage Information Example Not configured CONFIGURATION The name-to-IP address table uses this mapping information to resolve host names. The no version of this command disables the mapping. OS10(config)# ip host dell 1.1.1.1 Supported Releases 10.2.0E or later ip name-server Configures up to a three IPv4 or IPv6 addresses used for network name servers. Syntax ip name-server ip-address [ip-address2 ip-address3] Parameters • ip-address - Enter the IPv4 or IPv6 address of a domain name server to use for completing unqualified names (incomplete domain names that cannot be resolved). • ip-address2 ip-address3 - (Optional) Enter up two additional IPv4 or IPv6 name servers, separated with a space. Default Command Mode Usage Information Example Not configured CONFIGURATION OS10 does not support sending DNS queries over a VLAN. DNS queries are sent out on all other interfaces, including the Management port. You can separately configure both IPv4 and IPv6 domain name servers. In a dual stack setup, the system sends both A (request for IPv4) and AAAA (request for IPv6) record requests to a DNS server even if you only configure this command. The no version of this command removes the IP name-server configuration. OS10(config)# ip name-server 10.1.1.5 Supported Releases 10.2.0E or later show hosts Displays the host table and DNS configuration. Syntax show hosts Parameters None Default Not configured Command Mode EXEC Usage Information This command displays domain and host information. Example OS10# show hosts Default Domain Name : dell.com Domain List : abc.com Name Servers : 1.1.1.1 20::2 Static Host to IP mapping Table Host IP-Address System management 337
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/337.png)