Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 478

qos-map traffic-class Creates user-defined trust map for queue mapping. In S5148F-ON, apply the traffic class only on the egress traffic. Syntax qos-map traffic-class map-name Parameters map-name - Enter the name of the queue trust map (up to 32 characters). Default Not configured Command Mode CONFIGURATION Usage Information The traffic class will route all traffic to the mapped queue if applied on the interface- or system-level. The no version of this command returns the value to the default. Example OS10(config)# qos-map traffic-class queue-map1 OS10(config-qos-map)# queue 1 qos-group 5 OS10(config-qos-map)# queue 2 qos-group 6 OS10(config-qos-map)# queue 3 qos-group 7 OS10(config-qos-map)# Supported Releases 10.3.0E or later trust-map Applies a dot1p or dscp traffic class to a queue trust map. Syntax Parameters trust {dot1p | dscp} trust-map-name • dot1p- Applies a dot1p trust map. • dscp-Applies a dscp trust map. Default Command Mode Disabled SYSTEM-QOS INTERFACE Usage Information Example Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp] [string] command to view the current trust mapping. You should change the trust map only during no traffic flow, and verify the correct policy maps are applied. The no version of this command returns the value to the default. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# trust-map dscp dscp-trustmap1 Supported Releases 10.3.0E or later 478 Quality of service