Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 400
permit icmp (IPv6), permit ip
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 400 highlights
Command Mode Usage Information Example IPV4-ACL The no version of this command removes the filter. OS10(config)# ip access-list testflow OS10(conf-ipv4-acl)# permit icmp any any capture session 1 Supported Releases 10.2.0E or later permit icmp (IPv6) Configures a filter to permit all or specific ICMP messages. Syntax permit icmp [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment] Parameters • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: • capture - (Optional) Capture packets the filter processes. • dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. • fragment - (Optional) Use ACLs to control packet fragments. • host ipv6-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# permit icmp any any capture session 1 Supported Releases 10.2.0E or later permit ip Configures a filter to permit all or specific packets from an IP address. Syntax Parameters permit ip [A.B.C.D | A.B.C.D/x | any | host ip-address] [[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp | fragments] • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits to match to the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: • capture - (Optional) Capture packets the filter processes. • dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. • fragments - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Not configured 400 Access Control Lists