Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 410
seq deny tcp (IPv6
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 410 highlights
Usage Information Example The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ip access-list egress OS10(conf-ipv4-acl)# seq 10 deny tcp any any capture session 1 Supported Releases 10.2.0E or later seq deny tcp (IPv6) Assigns a filter to deny TCP packets while creating the filter. Syntax Parameters seq sequence-number deny tcp [A::B | A::B/x | any | host ipv6-address [operator]] [A::B | A:B/x | any | host ipv6-address [operator]] [ack | fin | psh | rst | syn | urg] [capture | dscp value | fragment] • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: • capture - (Optional) Capture packets the filter processes. • dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. • fragment - (Optional) Use ACLs to control packet fragments. • ack - (Optional) Set the bit as acknowledgement. • fin - (Optional) Set the bit as finish-no more data from sender. • psh - (Optional) Set the bit as push. • rst - (Optional) Set the bit as reset. • syn - (Optional) Set the bit as synchronize. • urg - (Optional) Set the bit set as urgent. • operator - (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available: • eq - Equal to • gt - Greater than • lt - Lesser than • neq - Not equal to • range - Range of ports, including the specified port numbers. • host ip-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 deny tcp any any capture session 1 Supported Releases 10.2.0E or later 410 Access Control Lists
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/410.png)