Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 66
L3 mode configuration, Management interface
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
By default, a trunk interface carries only untagged traffic on the access VLAN - you must manually configure other VLANs for tagged traffic. 1 Select one of the two available options: • Configure L2 trunking in INTERFACE mode and the tagged VLAN traffic that the port can transmit. By default, a trunk port is not added to any tagged VLAN. You must create a VLAN before you can assign the interface to it. switchport mode trunk switchport trunk allowed vlan vlan-id-list • Reconfigure the access VLAN assigned to a L2 access or trunk port in INTERFACE mode. switchport access vlan vlan-id 2 Enable the interface for L2 traffic transmission in INTERFACE mode. no shutdown L2 interface configuration OS10(config)# interface ethernet 1/1/7 OS10(conf-if-eth1/1/7)# switchport mode trunk OS10(conf-if-eth1/1/7)# switchport trunk allowed vlan 5,10 OS10(conf-if-eth1/1/7)# no shutdown L3 mode configuration Ethernet and port-channel interfaces are in L2 access mode by default. When you disbale L2 mode and then assign an IP address to an Ethernet port interface, you place the port in L3 mode. Configure one primary IP address in L3 mode. You can configure up to 255 secondary IP addresses on an interface. At least one interface in the system must be in L3 mode before you configure or enter a L3 protocol mode, such as OSPF. 1 Remove a port from L2 switching in INTERFACE mode. no switchport 2 Configure L3 routing in INTERFACE mode. Add the keyword secondary to configure backup IP addresses. ip address address [secondary] 3 Enable the interface for L3 traffic transmission in INTERFACE mode. no shutdown L3 interface configuration OS10(config)# interface ethernet 1/1/9 OS10(conf-if-eth1/1/9)# no switchport OS10(conf-if-eth1/1/9)# ip address 10.10.1.92/24 OS10(conf-if-eth1/1/9)# no shutdown View L3 configuration error OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ip address 1.1.1.1/24 % Error: remove Layer 2 configuration before assigning an IP Management interface The Management interface provides management access to the network device. You can configure the Management interface, but the configuration options on this interface are limited. You cannot configure gateway addresses and IP addresses if it appears in the main routing table, and proxy ARP is not supported on this interface. 1 Configure the Management interface in CONFIGURATION mode. interface mgmt 1/1/1 2 Configure an IP address and mask on the Management interface in INTERFACE mode. ip address A.B.C.D/prefix-length 66 Interfaces
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/66.png)