Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 403
permit udp, permit udp (IPv6
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
permit udp Configures a filter that allows UDP packets meeting the filter criteria. Syntax permit udp [A.B.C.D | A.B.C.D/x | any | host ip-address [eq | lt | gt | neq | range]] [[A.B.C.D | A.B.C.D/x | any | host ip-address [eq | lt | gt | neq | range] ] [ack | fin | psh | rst | syn | urg] [capture | dscp value | fragment] Parameters • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: • capture - (Optional) Capture packets the filter processes. • dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. • fragment - (Optional) Use ACLs to control packet fragments. • eq - (Optional) Permit packets which are equal to. • lt - (Optional) Permit packets which are less than. • gt - (Optional) Permit packets which are greater than. • neq - (Optional) Permit packets which are not equal to. • range - (Optional) Permit packets with a specific source and destination address. • ack - (Optional) Set the bit as acknowledgement. • fin - (Optional) Set the bit as finish-no more data from sender. • psh - (Optional) Set the bit as push. • rst - (Optional) Set the bit as reset. • syn - (Optional) Set the bit as synchronize. • urg - (Optional) Set the bit set as urgent. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Usage Information Example Not configured IPV4-ACL The no version of this command removes the filter. OS10(config)# ip access-list testflow OS10(conf-ipv4-acl)# permit udp any any capture session 1 Supported Releases 10.2.0E or later permit udp (IPv6) Configures a filter to permit UDP packets meeting the filter criteria. Syntax permit udp [A::B | A::B/x | any | host ipv6-address [operator]] [A::B | A:B/x | any | host ipv6-address [operator]] [ack | fin | psh | rst | syn | urg] [capture | dscp value | fragment] Parameters • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. Access Control Lists 403
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/403.png)