Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 521
Restore factory defaults, SupportAssist - factory reset
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 521 highlights
| | | set root='(hd0,gpt7)' | | echo 'Loading OS10 ...' | | linux (hd0,gpt7)/boot/os10.linux console=ttyS0,115200 root=/dev/sda7 \rw init=/bin/bash | | initrd (hd0,gpt7)/boot/os10.initrd | 6 Press Ctrl + x to reboot your system. The system boots up to a root shell without a password. 7 Enter linuxadmin for the username at the system prompt. root@OS10: /# linuxadmin 8 Enter your password at the system prompt, then enter the new password twice. root@OS10: /# passwd linuxadmin Enter new UNIX password: xxxxxxxxx Retype new UNIX password: xxxxxxxxxx passwd: password updated successfully 9 Reboot the system, then enter your new password. root@OS10:~# reboot -f Rebooting. [ 3466.946967] reboot: Restarting system BIOS Boot Selector for S5148F Primary BIOS Version 3.36.0.1-2 SMF Version: MSS 1.2.2, FPGA 0.1 Last POR=0x11, Reset Cause=0x55 Restore factory defaults Reboots the system to ONIE Rescue mode to restore the ONIE-enabled device to factory defaults. CAUTION: Restoring factory defaults erases any installed operating system and requires a long time to erase storage. ONIE Rescue bypasses the installed operating system and boots the system into ONIE until you reboot the system. After ONIE Rescue completes, the system resets and boots to the ONIE console. 1 Use the up and down arrows to select the ONIE: Rescue, then press Enter. The highlight entry (*) runs automatically in the operating system. |*ONIE: Install OS | | ONIE: Rescue | | ONIE: Uninstall OS | | ONIE: Update ONIE | | ONIE: Embed ONIE | | ONIE: Diag ONIE | 2 Press Enter again to enable the console. 3 Use the onie-uninstall command to return to the default ONIE settings. ONIE:/ # onie-uninstall Erasing unused NOR flash region Erasing 128 Kibyte @ 20000 - 100% complete. Erasing internal mass storage device: /dev/mmcblk0 (7832MB) Percent complete: 100% SupportAssist By default, SupportAssist is enabled. SupportAssist sends troubleshooting data securely to Dell Technical Support. SupportAssist does not support automated email notification at the time of hardware fault alert, automatic case creation, automatic part dispatch, or reports. To disable SupportAssist, use the eula-consent support-assist reject command. Troubleshoot OS10 521
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/521.png)