Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 288

Default • max-interval - Sets the maximum amount of time the system waits before sending the LSA in milliseconds (1 to 600,000). . • start-interval - 0 milliseconds • hold-interval - 5000 milliseconds • max-interval - 5000 milliseconds Command Mode Usage Information Example ROUTER-OSPF The no version of this command removes the LSA transmit timer. OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# timers throttle lsa all 100 300 1000 Supported Releases 10.2.0E or later OSPFv3 OSPFv3 is an IPv6 link-state routing protocol that supports IPv6 unicast address families (AFs). OSPFv3 is disabled by default. You must configure at least one interface, either physical or loopback. The OSPF process automatically starts when OSPFv3 is enabled for one or more interfaces. Any area besides area 0 can have any number ID assigned to it. Enable OSPFv3 1 Enable OSPFv3 globally and configure an OSPFv3 instance in CONFIGURATION mode. router ospfv3 instance-number 2 Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode. interface ethernet node/slot/port[:subport] 3 Enable (or bring up) the interface in INTERFACE mode. no shutdown 4 Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode. no switchport 5 Assign an IPv6 address to the interface in INTERFACE mode. If you are using a Loopback interface, see Loopback Interfaces ipv6 address ipv6-address/mask 6 Enable the OSPFv3 on an interface in INTERFACE mode. ipv6 ospfv3 process-id area area-id • process-id - Enter the OSPFv3 process ID for a specific OSPFv3 process (1 to 65535). • area-id - Enter the OSPF area ID as an IP address (A.B.C.D) or number (1 to 65535). Enable OSPFv3 OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# exit OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# no shutdown OS10(conf-if-eth1/1/1)# no switchport OS10(conf-if-eth1/1/1)# ipv6 address fe80::20c:29ff:fe0a:d59/64 OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0 288 Layer 3