Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 388
description, ip access-group
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 388 highlights
• operator - (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available: • eq - Equal to • gt - Greater than • lt - Lesser than • neq - Not equal to • range - Range of ports, including the specified port numbers. • host ipv6-address - (Optional) Enter the keyword and the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# deny udp any any capture session 1 Supported Releases 10.2.0E or later description Configures an ACL description. Syntax description text Parameters text - Enter the description text string. A maximum of 80 characters. Default Disabled Command Modes IPV4-ACL, IPV6-ACL, MAC-ACL Usage Information The no version of this command deletes the ACL description. Example OS10(conf-ipv4-acl)# description ipacltest Supported Releases 10.2.0E or later ip access-group Assigns an IP access group to an interface. Syntax Parameters ip access-group access-list-name {in | out} • access-list-name - Enter the name of an IPv4 access list. A maximum of 140 characters. • in - Apply the ACL to incoming traffic. • out - Apply the ACL to outgoing traffic. Default Command Mode Usage Information Not configured INTERFACE The no version of this command deletes an IP ACL configuration. 388 Access Control Lists
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/388.png)