Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 296
ipv6 ospf priority, log-adjacency-changes, maximum-paths
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 296 highlights
Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf passive Supported Releases 10.3.0E or later ipv6 ospf priority Sets the priority of the interface to determine the designated router for the OSPFv3 network. Syntax ipv6 ospf priority number Parameters number - Enter a router priority number (0 to 255). Default 1 Command Mode INTERFACE Usage Information When two routers attached to a network attempt to become the designated router, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf priority 4 Supported Releases 10.3.0E or later log-adjacency-changes Enables logging of syslog messages about changes in the OSPFv3 adjacency state. Syntax log-adjacency-changes Parameters None Default Disabled Command Mode ROUTER-OSPFv3 Usage Information The no version of this command resets the value to the default. Example OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# log-adjacency-changes Supported Releases 10.3.0E or later maximum-paths Enables forwarding of packets over multiple paths. Syntax Parameters Default Command Mode Usage Information Example maximum-paths number number -Enter the number of paths for OSPFv3 (1 to 64). Disabled ROUTER-OSPFv3 The no version of this command resets the value to the default. OS10(config)# router ospfv3 OS10(config-router-ospfv3-100)# maximum-paths 1 Supported Releases 10.3.0E or later 296 Layer 3
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er1-6fa6c40/296.png)