Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 252

OS10(conf-if-eth1/1/1)# ipv6 address autoconfig OS10(conf-if-eth1/1/1)# Supported Releases 10.3.0E or later ipv6 address dhcp Enables DHCP client operations on the interface. Syntax Parameters Defaults Command Mode Usage Information Example ipv6 address dhcp None None INTERFACE The no version of this command disables the DHCP operations on the interface. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address dhcp Supported Releases 10.3.0E or later ipv6 route Configures a static IPv6 static route. Syntax Parameters ipv6 route ipv6-prefix mask {next-hop | interface interface-type [routepreference]} • ipv6-prefix - Enter the IPv6 address in x:x:x:x::x format • mask - Enter the mask in slash prefix-length format (/x) • next-hop - Enter the next-hop IPv6 address in x:x:x:x::x format. • interface interface-type - Enter the interface type then the slot/port or number information. The interface types supported are: Ethernet, port-channel, VLAN. • route-preference - (Optional) Enter a route-preference range (1 to 255). Default Command Mode Usage Information Not configured CONFIGURATION • When the interface fails, the system withdraws the route. The route reinstalls when the interface comes back up. When a recursive resolution is broken, the system withdraws the route. The route reinstalls when the recursive resolution is satisfied. After you create an IPv6 static route interface, if you do not assign an IP address to a peer interface, you must manually ping the peer to resolve the neighbor information. • The no version of this command deletes the IPv6 route configuration. Example OS10(config)# ipv6 route 2111:dddd:0eee::22/128 2001:db86:0fff::2 Supported Releases 10.2.0E or later 252 Layer 3