Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 295

Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf dead-interval 10 Supported Releases 10.3.0E or later ipv6 ospf hello-interval Sets the time interval between hello packets sent on an interface. Syntax ipv6 ospf hello-interval seconds Parameters seconds - Enter the hello-interval value in seconds (1 to 65535). Default 10 seconds Command Mode INTERFACE Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30 Supported Releases 10.3.0E or later ipv6 ospf network Sets the network type for the interface. Syntax ipv6 ospf network {point-to-point | broadcast} Parameters • point-to-point - Sets the interface as part of a point-to-point network. • broadcast - Sets the interface as part of a broadcast network. Default Command Mode Usage Information Example Broadcast INTERFACE The no version of this command resets the value to the default. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ipv6 ospf network broadcast Supported Releases 10.3.0E or later ipv6 ospf passive Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface. Syntax ipv6 ospf passive Parameters None Default Not configured Command Mode INTERFACE Usage Information You must configure the interface before setting the interface to passive mode. The no version of the this command disables the Passive interface configuration. Layer 3 295