Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R1 - Page 406
seq deny (MAC
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 406 highlights
• udp - (Optional) Enter the UDP address to deny. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Determine route types: • capture - (Optional) Enter to capture packets the filter processes. • dscp value - (Optional) Enter to deny a packet based on the DSCP values, from 0 to 63. • fragment - (Optional) Enter to use ACLs to control packet fragments. • host ipv6-address - (Optional) Enter to use an IPv6 host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 5 deny ipv6 any any capture session 1 count Supported Releases 10.2.0E or later seq deny (MAC) Assigns a sequence number to a deny filter in a MAC access list while creating the filter. Syntax seq sequence-number deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • nn:nn:nn:nn:nn:nn - Enter the source MAC address. • 00:00:00:00:00:00 - (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies. • any - (Optional) Set all routes which are subject to the filter: • protocol-number - Protocol number identified in the MAC header, from 600 to ffff. • capture - (Optional) Capture packets the filter processes. • cos - (Optional) CoS value, from 0 to 7. • vlan - (Optional) VLAN number, from 1 to 4093. Default Command Mode Usage Information Example Not configured CONFIG-MAC-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# mac access-list macacl OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7 OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2 Supported Releases 10.2.0E or later 406 Access Control Lists