HP Integrity rx2800 Installation Guide - Page 28

Installing a hot-plug SAS hard drive, Memory DIMMs

Get HP Integrity rx2800 - i2 PDF manuals and user guides View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Externally accessible components: • SAS hard drives • Power supplies Internal components: • Memory DIMMs • Processors • PCIe cards WARNING! Ensure that the system is powered off and all power sources are disconnected from the server prior to removing or installing server hardware (unless you are removing or installing a hot-swappable or hot-pluggable component). Voltages are present at various locations within the server whenever an AC power source is connected. This voltage is present even when the main power switch is turned off. Failure to observe this warning can result in personal injury or damage to the equipment. Installing a hot-plug SAS hard drive There are eight hot-plug SAS hard drive slots located on the front of the server. Slots without hard drives installed have slot fillers installed for cooling purposes. IMPORTANT: SAS hard drives are loaded in order, starting with slot 1 Save the hard drive filler for future use. For airflow purposes, place hard drive fillers in slots that do not contain hard drives. 1. Remove the hard drive filler. Figure 2-1 Hard drive filler removal 2. Install the hard drive. Figure 2-2 Hard drive installation 28 Installing the server

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
Externally accessible components:
•
SAS hard drives
•
Power supplies
Internal components:
•
Memory DIMMs
•
Processors
•
PCIe cards
WARNING!
Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware (unless you are removing or
installing a hot-swappable or hot-pluggable component).
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to the equipment.
Installing a hot-plug SAS hard drive
There are eight hot-plug SAS hard drive slots located on the front of the server. Slots without
hard drives installed have slot fillers installed for cooling purposes.
IMPORTANT:
SAS hard drives are loaded in order, starting with slot 1
Save the hard drive filler for future use. For airflow purposes, place hard drive fillers in slots
that do not contain hard drives.
1.
Remove the hard drive filler.
Figure 2-1 Hard drive filler removal
2.
Install the hard drive.
Figure 2-2 Hard drive installation
28
Installing the server