HP Integrity rx2800 Installation Guide - Page 29
Installing a hot-Swap power supply
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Installing a hot-Swap power supply The server has at least one hot-swap power supply installed before shipping. This power supply is located at the rear of the server. You can install a second, optional power supply to provide 1+1 capability. Figure 2-3 Power supply loading guidelines 1 Power supply bay 2 To install the component: 2 Power supply bay 1 CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions can result in damage to the server. CAUTION: If you do not purchase a second power supply, the empty power supply slot must remain covered with the supplied power supply blank. Failure to observe this caution can result in server shutdown due to overheating. NOTE: The power supply is a hot-swappable device. You do not need to interact with the operating system to add a power supply to the server. 1. Remove the power supply blank. Figure 2-4 Removing the blank Installing Additional Components 29