HP MSA2324sa HP StorageWorks 2300 Family Modular Smart Array CLI reference gui - Page 103
set network-parameters, Optional. An IP subnet mask for the port.
View all HP MSA2324sa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
set network-parameters Description Sets IP values for controller module network ports. IP values can be set dynamically using Dynamic Host Configuration Protocol (DHCP) for both controllers, or manually (statically) for each controller. If DHCP is enabled, manually setting an IP value for either controller disables DHCP for both controllers. Syntax To set both controllers' IP values dynamically: set network-parameters dhcp To set a controller's IP values manually: set network-parameters [ip address] [netmask netmask] [gateway gateway] controller a|b Parameters dhcp Specifies to use DHCP to set both controllers' IP values. ip address Optional. An IP address for the port. netmask netmask Optional. An IP subnet mask for the port. gateway gateway Optional. A gateway IP address for the port. controller a|b Specifies whether to apply the settings to controller A or B. Example Use DHCP to set network port IP values: # set network-parameters dhcp Manually set network port IP values for controller A (disabling DHCP for both controllers, if it was enabled): # set network-parameters ip 192.168.0.10 netmask 255.255.255.0 gateway 192.168.0.1 controller a Success: Network parameters have been changed See also • show network-parameters HP StorageWorks 2000 G2 Modular Smart Array CLI Reference Guide 103