HP Mellanox SX1018 Mellanox MLNX-OS®Command Reference Guide for SX101 - Page 312
show interfaces ethernet, show interfaces ethernet <inf> [counters [priority]]
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 312 highlights
Rev 1.6.9 show interfaces ethernet show interfaces ethernet [counters [priority]] Displays the configuration and status for the interface. Syntax Description inf Interface number: /. counters Displays interface extended counters. priority Displays interface extended counters, per priority (0-7). Default N/A Configuration Mode Any Command Mode History 3.1.0000 Role admin Example switch (config) # show interfaces ethernet 1/1 Eth1/1 Admin state: Enabled Operational state: Up Description: N\A Mac address: 00:02:c9:71:ed:2d MTU: 1500 bytes(Maximum packet size 1522 bytes) Flow-control: receive off send off Actual speed: 40 Gbps Width reduction mode: Not supported Switchport mode: access Last clearing of "show interface" counters 00:20:39 60 seconds Ingress rate: 0 bits/sec, 0 bytes/sec, 0 packets/sec 60 seconds Egress rate: 0 bits/sec, 0 bytes/sec, 0 packets/sec Rx 0 packets 0 unicast packets 0 multicast packets 0 broadcast packets 0 bytes 0 error packets 0 discard packets Tx 63 0 63 0 4032 0 packets unicast packets multicast packets broadcast packets bytes discard packets Related Commands switch (config) # Note Mellanox Technologies 312 Mellanox® Technologies Confidential