HP Mellanox SX1018 Mellanox MLNX-OS®Command Reference Guide for SX101 - Page 42
show interface, show interface {<ifname> [con d | brief]}, Syntax Description, Default
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Rev 1.6.9 show interface show interface { [configured | brief]} Displays information about the specified interface, configuration status, and counters. Syntax Description ifname The interface name e.g., "mgmt0", "mgmt1", "lo" (loopback), etc. configured Displays the interface configuration. brief Displays a brief info on the interface configuration and status. Default N/A Configuration Mode Any Command Mode History 3.1.0000 Role admin Example switch (config) #show interfaces mgmt0 configured Interface mgmt0 configuration Enabled: yes DHCP: yes Zeroconf: no IP address: Netmask: IPv6 enabled: yes Autoconf enabled: no Autoconf route: yes Autoconf privacy: no IPv6 addresses: 0 Speed: auto Duplex: auto MTU: 1500 Comment: my-interface switch (config) # show interfaces mgmt0 brief Interface mgmt0 state Admin up: yes Link up: yes IP address: 172.30.2.2 Netmask: 255.255.0.0 IPv6 enabled: yes Autoconf enabled: no Autoconf route: yes Autoconf privacy: no IPv6 addresses: 1 IPv6 address: fe80::202:c9ff:fe5e:a5d8/64 Speed: 1000Mb/s (auto) Duplex: full (auto) Interface type: ethernet Interface ifindex: 2 Interface source: physical MTU: 1500 HW address: 00:02:C9:5E:A5:D8 Comment: my-interface switch (config) # Mellanox Technologies 42 Mellanox® Technologies Confidential