HP Mellanox SX1018 Mellanox MLNX-OS®Command Reference Guide for SX101 - Page 323
channel-group
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 323 highlights
Rev 1.6.9 channel-group channel-group [mode {on | active | passive}] no channel-group Assigns and configures a physical interface to a port channel. The no form of the command removes a physical interface from the port-channel. Syntax Description 1-4096 The port channel number. mode on Static assignment the port to LAG. LACP will not be enabled on this port. mode active/passive Dynamic assignment of the port to LAG. LACP will be enabled in either passive or active mode. Default N/A Configuration Mode Config Interface Ethernet History 3.1.1400 Role admin Example switch (config interface 1/7)# channel-group 1 mode active switch (config interface 1/7)# show interfaces port-channel summary Flags: D- Down P - Up in port-channel (members) I - Individual H - Hot-standby (LACP only) s - Suspended r - Module-removed U - Up (port-channel) Group Port- Type Member Ports Channel 1 Po1(D) LACP Eth1/7(D) Related Commands switch (config interface 1/7)# show interfaces port-channel summary show interfaces port-channel compatibility-parameters show lacp interfaces ethernet Note • Setting the mode to active/passive is possible only in LACP is enabled. • The first port in the LAG decide if the LAG will be static ("on") or LACP ("active" , "pasive"). • All the ports in the LAG must have the same configuration, determines by the first port added to the LAG. The port with a different configuration will be rejected, for the list of dependencies refer to 'show interfaces port-channel compatibility-parameters' Mellanox Technologies 323 Mellanox® Technologies Confidential