HP StorageWorks 2/140 director product manager user guide - Page 161

Using Maintenance Features Use the following steps to reset the configuration parameters on the director to the default values. 1. Choose Reset Configuration from the Maintenance menu. The following warning displays: WARNING: This operation will reset all director configuration data and nonvolatile settings to factory default values. The director must be offline to continue. 2. Set the director offline. For instructions, refer to "Set Online State" on page 5-4. 3. To continue the reset operation, click Reset on the Reset Configuration dialog box. If you want to cancel the operation, click Cancel. NOTE: If you have enabled features that add additional port function since the director was shipped from the factory, these features will be disabled (factory default) when the configuration is reset. Only those ports that were enabled at the factory will function. You will have to enable the additional port function features again through the Configure Feature Key dialog box. NOTE: Factory-default values may vary, depending on the firmware release installed in your director. For a list of values, refer to the hp StorageWorks director 2/64 service manual for the Director 2/64 and the hp StorageWorks director 2/140 service manual for the Director 2/140. Table 5-1: Data Default Values Configuration Identification Description Director Name Director Description Director Contact Director Location Ports Port Names Port Blocked States Extended Distance (10-100km) LIN Alerts Port Address Default NULL string "Fibre Channel Director" "End User Contact (please configure)" "End User Contact (please configure)" NULL strings Unblocked Disabled Disabled Port number plus 4 director product manager user guide 5-9