HP StorageWorks 2/140 director product manager user guide - Page 182
E-Ports in S/390
View all HP StorageWorks 2/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Information and Error Messages Table A-1: Product Manager Messages (Continued) Message Cannot enable beaconing while the system light is on. Cannot have E-Ports in S/390 mode unless SANtegrity feature is installed. Please contact your sales representative. Cannot have spaces in field. Cannot install firmware to a director with a failed CTP card. Cannot modify director/switch speed. Ports cannot be configured at a higher data rate than the director/speed. Description Occurs when choosing Enable Beaconing option for a failed FRU. User attempted to change operating mode from Open Systems to S/390 mode with E_Ports configured, but SANtegrity is not installed. Spaces are not allowed as part of the entry for this field. A firmware version cannot be installed on a director with a failed control processor (CTP) card. Port speeds cannot be configured at a higher data rate than the director speed. This message displays when you set director sped to 1 GB/sec through the Configure Operation Parameters dialog box and at least one of the ports is running at 2 Gb/sec. Action Replace FRU and enable beaconing again or enable beaconing on an operating FRU. Informational message. If you install SANtegrity before changing to S/390 mode, then E_Ports will remain as E_Ports when you change to S/390 mode. If SANtegrity is not installed, setting a director to S/390 mode will change all E_ports to G_Ports. Delete spaces from the field entry. Replace the failed CTP card and retry the firmware installation. Either return the director speed to 2 Gb/sec or configure all port data speeds to 1 Gb/sec through the Configure Ports dialog box. A-4 director product manager user guide