HP StorageWorks 2/140 director product manager user guide - Page 204

Information and Error Messages Table A-1: Product Manager Messages (Continued) Message Stop diagnostics failed. The test is already running. Stop diagnostics failed. The test was not running. Switch Binding was removed from attached devices that are also participating in Port Binding. Please review the Port Binding Configuration. System diagnostics cannot run. The Operational Status is invalid. The add firmware process has been aborted. The data collection process failed. Description Diagnostics for the port was not running and Stop was selected on the Port Diagnostics dialog box. Diagnostics quit for the port for some reason, but the Stop button remains enabled. This action failed because the test was not running. The device WWNs were removed from the director's Switch Membership List (SANtegrity Switch Binding feature), but you should note that one or more of these devices still has security control in port binding. System diagnostics cannot run on switches with failed ports The user aborted the process to add a firmware version to the HAFM Server's firmware library. An error occurred while performing the data collection procedure. Action Verify port operation. Retry diagnostics for the port and choose Stop from the dialog box. If problem persists, contact the next level of support. Informational message. Verify that the security level for each device is as required by reviewing the Bound WWN list in the Configure Ports dialog box. Replace failed ports. Verify the firmware addition is to be aborted, then click OK to continue. Try the data collection procedure again. If the problem persists, contact the next level of support. A-26 director product manager user guide