HP StorageWorks 2/140 director product manager user guide - Page 202

Information and Error Messages Table A-1: Product Manager Messages (Continued) Message Performing this operation will change the current state to Offline. Performing this operation will change the current state to Online. Periodic Date/Time synchronization must be cleared. Port binding was removed from attached devices that are also participating in Switch Binding. Port cannot swap to itself. Port diagnostics cannot be performed on an inactive port. Port speeds cannot be configured at a higher rate than the director speed. Description This message requests confirmation to set the director offline. This message requests confirmation to set the director online. Action cannot be performed because Periodic Date/Time Synchronization option is active. Informational message. User has removed Port Binding from attached devices, but one or more of these devices is still controlled by Fabric Binding. Port addresses entered in the Swap Ports dialog box are the same. This displays when port diagnostics is run on a port in an inactive state. This displays when you configure a port to 2 Gb/sec and the director speed is set to 1 Gb/sec. Action Click OK to set the director offline or click Cancel to cancel the operation. Click OK to set the director online or click Cancel to cancel the operation. Click Periodic Date/Time Synchronization check box in Configure Date and Time dialog box (Configure menu) to clear check mark and disable periodic date/time synchronization. Review the Switch Binding Membership List to determine if the devices should be members. Ensure that address in the first and second port address fields are different. Run the diagnostics on an active port. Set the director speed to 2 Gb/sec in the Configure Operating Parameter dialog box. A-24 director product manager user guide