HP StorageWorks 2/140 director product manager user guide - Page 80
Con Switch, Parameters, Con Switch Parameters, Threshold Alert, Product Manager.
![]() |
View all HP StorageWorks 2/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Monitoring and Managing the Director - 06 N_Port connection not allowed on this port. The port type configuration does not match the actual port use (the port is configured as an E_Port, but attaches to a node device). - Non-HP switch at other end of the ISL. The cable is connected to a non-HP switch, and Interop mode is set to Homogeneous mode. - 08 ISL connection not allowed on this port. The port type configuration does not match the actual port use (the port is configured as an F_Port, but attaches to a director or switch). - 10 Port binding violation-Unauthorized WWN. The WWN that was entered to configure port binding for this port is not valid, or a nickname was used that was not configured for the attached device in the Product Manager. - 11 Unresponsive node connected to port. Possible causes are: (1) a hardware problem on a switch or connected node where ELP frames are not delivered; the response is not received, or a fabric login (FLOGI) cannot be received (there may be problem in the switch SBAR); (2) a faulty or dirty cable connection; (3) faulty host bus adapters that do not send out a FLOGI within a reasonable timeframe. Reason messages for an inactive state include: - 1 Switch speed conflict (Director 2/64 only). The director data speed was set to 2 Gb/sec, but the port only supports 1 Gb/sec operation because it is on an FPM port card. (All ports on all installed FPM cards will go inactive if the director data speed is set to 2 Gb/sec.) To activate the port, either set the director data speed to 1 Gb/sec using the Configure Switch Parameters dialog box, or replace the FPM card with a UPM card. - 2 Optics speed conflict (Director 2/64 only). The port data speed was set to 2 Gb/sec, but the director data speed was set to 1 Gb/sec. To activate the port, set the director data speed to 2 Gb/sec using the Configure Switch Parameters dialog box. Note that a port could also be inactive if the card is an FPM card and the port data speed was set to 2 Gb/sec. To activate the port in this case, set director data speed to 1 Gb/sec, or replace the FPM card with a UPM card. NOTE: Your director model and firmware may not allow variable data speed settings. • Threshold Alert-If a threshold alert exists for the port, an alert indicator (yellow triangle) displays by the Threshold Alert field, and the configured name for the last alert received displays in the field. 2-20 director product manager user guide
![](/manual_guide/products/hewlettpackard-storageworks-2140-director-product-manager-user-guide-466694f/80.png)