HP StorageWorks 2/140 director product manager user guide - Page 83

Monitoring and Managing the Director Swap Ports (S/390 mode only) Click this while in S/390 mode to display the Swap Ports dialog box. Use this dialog box to swap addresses between ports. Clear Link Incident Alerts Click this to clear the attention indicator on the Hardware View, the Port List View, and the Performance View. In addition, the procedure clears the status description in Port Properties dialog boxes. If there are no link incident alerts set for a port, no actions occur. Although you can manually clear link incidents, they may also be cleared by actions outside of the user interface, such as when rebooting the HAFM server. Reset Port Click to display a confirmation dialog box. Click Yes on that dialog box to reset the port. If a switch is attached to the port and is online, this operation sends a link reset to the attached switch; otherwise, this action disables port beaconing for the port. And if the port is in a failed state, such as after failing a loopback test, the reset restores the port to an operational state, clearing the service required (amber) LED. The reset does not affect other ports in the switch. Port Binding Click to display the Port Binding dialog box. Click the Port Binding check box to enable port binding. Either choose the Attached WWN option to bind to the attached device listed, or choose Detached WWN to enter the WWN or nickname of the device to bind. Figure 2-12: Port Binding dialog box Port Binding dialog box parameters: director product manager user guide 2-23