HP StorageWorks MSA2012i HP StorageWorks 2000 Modular Smart Array Reference Gu - Page 39
Configuring Host Ports
View all HP StorageWorks MSA2012i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Configuring Host Ports This section describes how to configure host ports on Fibre Channel (FC) or iSCSI controller modules. No host-port configuration is needed for SAS controller modules. Configuring FC Host Ports On the Host Port Configuration page you can view the location, link speed, and topology of each FC host port in each controller module. Figure 2-1 Host Port Configuration Settings (Controller A) This page shows the following information: ■ Port number and location - The shaded box represents the physical position of the port on the controller module. For each port, the upper bar represents the host ports on controller module A and the lower bar represents host ports on controller module B. ■ Link Speed - 2 GBit/Second or 4 GBit/Second. A host port's link speed must match the speed of the HBA or switch to which the port is connected. ■ Topology - Either Loop or Point to Point. "Not Available IOM Down" appears if the controller is down and topology information is unavailable. On this page you can set FC host port link speeds. From the Advanced Options panel you can view and set the following: ■ FC host port loop ID ■ FC host port interconnect status (dual-controller system only) ■ FC host port topology Chapter 2 Configuring Your System for the First Time 39