HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, b180L se - Page 58
device. If an existing device already uses an ID, select
View all HP Visualize b180L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
NOTE: Table 6 NOTICE: Configuration FRU Configurations Table 6 lists the recommended SCSI IDs for internal storage devices. There are no jumper settings to change for the floppy drive. These SCSI IDs are the default IDs for each storage device. If an existing device already uses an ID, select an alternate ID. Default SCSI IDs Fast, Wide SCSI 1st Hard Disk Drive ID 6 2nd Hard Disk Drive ID 5 Note: The Fast, Wide SCSI controller is set to SCSI ID 7. Single-Ended SCSI CD-ROM Drive ID 2 DDS Drive ID 3 1st Hard Disk Drive ID 6 2nd Hard Disk Drive ID 5 Notes: The floppy drive is NOT a SCSI device. The SCSI controller is set to SCSI ID 7. Ultra Wide SCSI 1st Hard Disk Drive ID 6 2nd Hard Disk Drive ID 5 Note: The Ultra Wide SCSI controller is set to SCSI ID 7. The floppy disk drive is not a SCSI device. 36