IBM 86655RY Hardware Maintenance Manual - Page 102

8. Select Close to exit from the Network setup. When you restart the server, the failover function will be in effect. If a failover occurs, a message is written to the NT Event Viewer log. In addition, if the Enable for DMI / Hot Swap Support checkbox is checked, a DMI alert will also be generated. IntraNetWare: The IBM PCI Hot Plug System Bus Driver Diskette for Novell Netware V4.41, V4.42, and V5.0 is available for download from the IBM Web site at: http://www.pc.ibm.com/support The failover function is now enabled. If a failover occurs: • The operating system console generates a message. • The custom counters for the device driver contain variables that define the state of the failover function and the location of the redundant pair. You can use the NetWare Monitor to view the custom counters. Note: If the primary adapter was hot-replaced while the Ethernet traffic was being handled by the secondary Ethernet controller, the traffic does not automatically switch back to the primary adapter when the primary adapter comes back online. In this case, issue the command: LOAD d:\path\PCNTNW SCAN where d and path are the drive and path where the driver is located. This command causes the device driver to locate the primary adapter and switch the Ethernet traffic to it. Ethernet port connector The following table shows the pin-number assignments for the RJ-45 connector. These assignments apply to both 10BASE-T and 100BASE-TX devices. Table 17. Ethernet RJ-45 connector pin-number assignments.. Pin Signal 1 Transmit data+ 2 Transmit data- 3 Receive data+ 4 Not connected Pin 5 Not connected 6 Receive data - 7 Not connected 8 Not connected Signal Advanced System Management ports Your server has three communication ports dedicated to the Netfinity Advanced System Management Processor. One port uses a standard D-shell serial-port connector, connector C. The other two ports, which are used for the ASM Interconnect function, use a dual RJ-45 connector. 92 Hardware Maintenance Manual: Netfinity 7600 - Type 8665 Models 1RY, 2RY