IBM 86655RY Hardware Maintenance Manual - Page 44

a. Tilt the battery so that you can insert it into the front of the socket, under the battery clip. b. As you slide it under the battery clip, press the battery down into the socket. 9. Reinstall any adapters that you removed. 10. Insert the plastic dividers into the divider guides. 11. Reinstall the top cover. Note: You must wait approximately 20 seconds after you plug the power cord of your server into an electrical outlet before the power control button becomes active. 12. Start the Configuration/Setup Utility program and set configuration parameters as needed. Refer to "Using the Configuration/Setup Utility program" on page 43. Diagnosing errors To find solutions to problems that have definite symptoms, see "Error symptoms" on page 225. If you cannot find the problem there, go to "Starting the diagnostic programs" on page 25 to test the server. If you have just added new software or a new option and the server is not working, do the following before using the error symptoms table: • Remove the software or device that you just added. • Run the diagnostic tests to determine if the server is running correctly. • Reinstall the new software or new device. Troubleshooting the Ethernet controller This section provides troubleshooting information for problems that might occur with the 10/100 Mbps Ethernet controller. Network connection problems If the Ethernet controller cannot connect to the network, check the following: • Make sure that the cable is installed correctly. The network cable must be securely attached at all connections. If the cable is attached but the problem persists, try a different cable. If you set the Ethernet controller to operate at 100 Mbps, you must use Category 5 cabling. 34 Hardware Maintenance Manual: Netfinity 7600 - Type 8665 Models 1RY, 2RY