IBM 86655RY Hardware Maintenance Manual - Page 141

Pop rivets Processor housing cover DIMM Memory board To replace the memory card assembly: 1. Power-off the server and all attached devices. Disconnect external cables and power cords and remove the top cover. 2. Pull up the two pop rivets on the processor housing cover and remove the cover from the processor housing. 3. Lift up on the memory card assembly and remove it from the server. Note: When setting down the memory card assembly, be sure to place the assembly only on a static-protective surface, such as a static-protective package. 4. Remove the memory modules (DIMMs) from the memory card assembly and seat them in the new memory card assembly. See "Installing memory-module kits" on page 71. Note: Be sure to put the memory modules in the same positions on the replacement assembly as they occupied on the assembly that has been removed from the server. 5. Install the memory card assembly: a. Hold the memory card assembly and align it over the memory card connector. b. Insert the memory card assembly into the connector. 6. Install the processor housing cover and push the two pop rivets down to secure the cover. FRU information (service only) 131