IBM 86655RY Hardware Maintenance Manual - Page 138
Disconnecting the shuttle, Front LED card assembly
View all IBM 86655RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
8. Replace the card and reattach the front LED card cable and the diagnostic switch card cable. Disconnecting the shuttle Review the information in "Before you begin" on page 60. 1. Power-off the server, if it is on. 2. Disconnect the power cord for each power source from the electrical outlet. Attention: The presence of ac standby power might result in damage to the hardware unless you disconnect the power cord for each power source from the electrical outlet. 3. Remove the top cover (see "Removing the top cover" on page 62). 4. Flip the top end of each diagonal side latch inward. 5. Move each latch toward the rear of the shuttle until the latch is vertical. 6. Fold the hinged top end of each latch outwards at the notch of the chassis. 7. Slide the shuttle toward the rear of the server. 8. To remove the shuttle, see "Removing the shuttle" on page 135. Front LED card assembly Review the information in "Before you begin" on page 60. 128 Hardware Maintenance Manual: Netfinity 7600 - Type 8665 Models 1RY, 2RY