IBM 86655RY Hardware Maintenance Manual - Page 88

If you install a strain-relief bracket option over the end of the power cord that is connected to the device, you must connect the other end of the power cord to an easily accessible power source. Replacing a hot-swap fan Before you begin: • Read "Safety information" on page 249. • Review the information in "Before you begin" on page 60. • Read the documentation that comes with the option. Refer to the following illustration to replace a hot-swap fan. Hot-swap fan assembly 1 Hot-swap fan assembly 3 Latch Hot-swap fan assembly 2 Hot-swap fan assembly 4 To replace a hot-swap fan assembly: 1. Review the information in "Before you begin" on page 60. 2. If you are replacing fan assembly 1, 2, or 3: a. Remove the top cover. Attention: To ensure proper system cooling, keep the cover removed for no more than 30 minutes during this procedure. b. Press the fan release latch and lift the fan assembly out of the server. c. Slide the replacement fan assembly into the server. The latch will snap into place and secure the fan in the server. d. Replace the top cover 3. If you are replacing fan assembly 4: 78 Hardware Maintenance Manual: Netfinity 7600 - Type 8665 Models 1RY, 2RY