IBM 86655RY Hardware Maintenance Manual - Page 239
Cable, I/O Legacy Board, Fixed Disk Drive, Error Code/Symptom, FRU/Action
![]() |
View all IBM 86655RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
Error Code/Symptom FRU/Action 1301 found) (cable to front panel not 1. Cable 2. Front Panel 3. Power Switch Assembly 4. I/O Legacy Board 1302 (cable from system board to power on and reset switches not found) 1. Cable 2. Power Switch Assembly 3. I/O Legacy Board 1303 (cable from system board to power backplane not found) 1. Cable 2. Power Backplane 3. I/O Legacy Board 1304 (cable to diagnostic LED board not found) 1. Cable 2. Diagnostic LED Board 3. Power Switch Assembly 4. I/O Legacy Board 1600 (The Service Processor is not functioning) Do the following before replacing a FRU: 1. I/O Legacy Board 2. Processor/PCI Board 1. Ensure that a jumper is not installed on J51. 2. Remove the ac power to the system, wait 20 seconds; then, re-connect the ac power. Wait 30 seconds; then, power-on the system. 1601 (The system is able to 1. I/O Legacy Board communicate to the Service Processor, but the Service Processor failed to respond at 2. Processor/PCI Board the start of POST.) Do the following before replacing a FRU: 1. Remove the ac power to the system, wait 20 seconds; then, re-connect the ac power. Wait 30 seconds; then, power-on the system. 2. Flash update the Service Processor. 1762 (Fixed Disk Configuration error) 1. Fixed Disk Drive 2. Fixed Disk Cables 3. Run Configuration/Setup 4. Fixed Disk Adapter 5. SCSI Backplane 6. I/O Legacy Board 178X (Fixed Disk error) 1. Fixed Disk Cables 2. Run Diagnostics 3. Fixed Disk Adapter 4. Fixed Disk Drive 5. I/O Legacy Board Symptom-to-FRU index 229
![](/manual_guide/products/ibm-866561y-hardware-maintenance-manual-c694d19/239.png)