IBM 86655RY Hardware Maintenance Manual - Page 82

• If you install 16 GB of memory, the Configuration/Setup Utility will display the memory that is usable by the network operating system. This amount of memory might differ from the amount of memory you have installed. • Installing or removing DIMMs changes the configuration information in the server. Therefore, after installing or removing a DIMM, you must save the new configuration information in the Configuration/Setup Utility program. Refer to "Using the Configuration/Setup Utility program" on page 43 for more information. • Install the DIMMs in the order provided in Table 7. • For the locations of the DIMM connectors, see "Memory board component locations" on page 58. Table 7. DIMM installation order. Set of 4 DIMMs First set (shipped as standard) 2nd set 3rd set 4th set Install DIMMs in these connectors: J1, J5, J9, J13 J2, J6, J10, J14 J3, J7, J11, J15 J4, J8, J12, J16 Refer to the following illustration when installing memory. Pop rivets Processor housing cover DIMM Memory board 72 Hardware Maintenance Manual: Netfinity 7600 - Type 8665 Models 1RY, 2RY