IBM 86655RY Hardware Maintenance Manual - Page 157
Connect one end of a 68-pin ANSI American National Standards Institute, only
![]() |
View all IBM 86655RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
7. Insert the controller in the PCI expansion slot. Press the controller firmly into the slot so that it is fully seated. Note: The following illustration depicts the ServeRAID-4H controller. The ServeRAID-4L and -4M controllers will have a slightly different appearance. Figure 4. Inserting a ServeRAID-4H controller into the PCI expansion slot 8. Secure the controller by either tightening the expansion-slot screw on the top of the controller or closing the latch, depending on your server. 9. Connect the SCSI cables to the controller. If you intend to attach external devices only, go to step 13 on page 148. Otherwise, continue with step 10. 10. Connect one end of a 68-pin ANSI (American National Standards Institute) standard cable (separately purchased or already in your server) to the internal channel connector on the ServeRAID controller. Installing and configuring ServeRAID controllers 147
![](/manual_guide/products/ibm-866561y-hardware-maintenance-manual-c694d19/157.png)