Icom IC-92AD Instruction Manual - Page 27

4 FREQUENCY AND CHANNEL SETTING D Using the keypad 1 The frequency can be directly set via numeric keys. • Entering 433.580 MHz • Entering 80.200 MHz • Changing 100 kHz and below. 2 • If a frequency outside the frequency range is entered, the previously displayed frequency is automatically recalled after editing last digit. 4 DUP +DUP DTCS FM PRIO WX A 4 3 0 0 0 025 8 TS +DUP DTCS FM PRIO WX A 8 3 0 0 0 025 Editing 433.520 MHz to 433.140 MHz 3 4 q Push [VFO] to select VFO mode, if necessary. 3 A/a LOW +DUP DTCS FM PRIO WX A 4 3 0 0 0 025 +DUP DTCS FM PRIO WX 0 CQ A 8 0 0 0 0 025 . # CD T.SCAN +DUP DTCS FM PRIO WX A 4 3 3 1 4 025 5 6 w Enter the desired frequency via the keypad. +DUP DTCS +DUP DTCS +DUP DTCS 7 4 3 3 5 8 0 3 A/a LOW FM A PRIO WX 25 080 200 . # CD T.SCAN FM A PRIO WX 25 FM PRIO WX 1CLR SCOPE A 4 3 3 1 4 025 8 +DUP DTCS 5 SKIP FM PRIO WX A 4 3 3 5 8 025 2 SCAN +DUP DTCS FM PRIO WX A 0 8 0 2 0 025 4 DUP +DUP DTCS FM PRIO WX A 4 3 3 1 4 025 9 10 1CLR SCOPE 4 DUP 2 SCAN 5 SKIP 3 A/a LOW 6 M.NAME REC MODE 0 CQ VFOA MHz MR B S.MW 8 TS +DUP DTCS FM PRIO WX A 4 3 3 5 8 025 +DUP DTCS 0 CQ FM PRIO WX A 0 8 0 2 0 025 +DUP DTCS 0 CQ FM PRIO WX A 4 3 3 1 4 025 • Editing to 684 kHz +DUP DTCS +DUP DTCS 0 CQ 4 3 3 5 8 0 FM A PRIO WX 25 0 CQ FM PRIO WX A 0 8 0 2 0 025 0 .# CD 6 8 CQ T.SCAN M.NAME TS 4 DUP 11 12 13 14 15 7DSQ 8 TONE TS 9 CS DTMF.M .# CD T.SCAN CALLC RX CS 16 17 Depending on the tuning step setting, it may not be possible to input a 1 kHz digit. 18 In this case, enter "0" as 1 kHz digit, then rotate [DIAL] to set the desired frequency. 19 19