Icom IC-92AD Instruction Manual - Page 9
Accessory Attachment - antenna
View all Icom IC-92AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
1 ACCESSORY ATTACHMENT ■ Antenna Jack cover Insert the supplied antenna into the antenna connector and screw down the antenna as shown at left. NEVER carry the transceiver by holding the antenna. KEEP the jack cover attached when jack is not in use to protect the connector from dust and moisture. ✔ For your information Third-party antennas may increase transceiver performance. An optional AD-92SMA ANTENNA CONNECTOR ADAPTER is available to connect an antenna with a BNC connector. ■ Belt clip Supplied screws* *NOTE: USE the supplied screws only. Using screws longer than specified could damage the transceiver. ■ Hand strap 1 Slide the hand strap through the loop on the top of the belt clip as illustrated at left to facilitate carrying the transceiver. Handstrap ■ Battery pack Attach the Li-Ion battery pack (BP-256) or battery case (BP-257) as illustrated below. • Charge the Li-Ion battery pack before use. (pgs. 10, 11) Battery pack/Battery case CAUTION!: NEVER attach or detach the battery q pack when wet. Be careful when releasing the latch. Because the latch is tightly locked, don't use a finger nail to open it- you may injure yourself. Instead, use w something relatively flat, like the edge of a coin or the tip of a Latch screwdriver, to carefully release the latch. 1