Icom IC-92AD Instruction Manual - Page 82
Memory channel programming
![]() |
View all Icom IC-92AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
9 MEMORY/CALL CHANNELS ■ Memory channel programming q Push [VFO] to select VFO mode. w Set the desired frequency: ➥ Select the desired band with [BAND]. ➥ Set the desired frequency with [DIAL]. ➥ Or set the desired frequency with keypad directly. In this case, the band and frequency settings with [BAND] and [DIAL] as above are not required. ➥ Set other data (e.g. offset frequency, duplex direction, tone squelch, etc.), if desired. ePush and hold [S.MW](MR) for 1 sec. to enter select memory write mode. • 1 short and 1 long beep sound. • Memory channel number blinks. r Rotate [DIAL] to select the desired channel. • Call channels (C0, C1), VFO (VFO) and scan edge channels (0A/0B to 24A/24B), as well as regular memory channels, can be programmed in this way. t Push and hold [S.MW](MR) for 1 sec. to program. • 3 beeps sound. • Memory channel number automatically increases when continuing to push and hold [S.MW](MR) for 1 sec. after programming. [EXAMPLE]: Programming 145.870 MHz into memor y channel 11 (blank channel). VFO mode Push and hold MR B S.MW for 1 sec. to program. FM A145 870 PSKIP FM A145 870 PSKIP µ 011 Push and hold MR B S.MW for 1 sec. Enter select memory write mode. FM r146 010 µ 000 BANK :---- MNAME: SKIP :OFF Return to the VFO mode. FM A145 870 PSKIP [DIAL] Rotate [DIAL] to select channel 11. r µ 011 BANK :---- MNAME: SKIP :OFF Channel 11 MR B S.MW 74
![](/manual_guide/products/icom-ic92ad-instruction-manual-b1b3608/82.png)