Icom IC-92AD Instruction Manual - Page 31
Band scope
View all Icom IC-92AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
BASIC OPERATION 5 ■ Band scope The band scope function allows you to visually check a specified frequency range around the center frequency. About the sweep steps: The specified tuning step in each frequency band (in VFO mode) or programmed tuning step (in memory mode) is used during sweep. Single watch mode display +DUP DTCS FM PRIO WX EMR A B 1 4 5 7 8 025 PSKIP µ 000 Band scope indication Sweep marker D Single sweep q Set the desired frequency as band scope center fre- quency. • Push [MAIN/DUAL] to select "MAIN band" during dual watch. w Push and hold [SCOPE](1) for 1 sec. to start a single sweep. • 1 short and 1 long beeps sound. • Signal conditions (strengths) appear starting from the left of the range. e Rotate [DIAL] to set the highlighted cursor to the desired signal and set the frequency of the signal. r Push [VFO] to return to normal operation. D Continuous sweep 1 q Set the desired frequency as band scope center frequency. 2 • Push [MAIN/DUAL] to select "MAIN band" during dual watch. 3 w Push and hold [SCOPE](1) for 3 sec. to start continuous sweep. 4 • 2 short beeps sound after 1 short and 1 long beeps. 5 • Signal conditions (strengths) appear starting from the left of the range. 6 e Push and hold [SCOPE](1) for 1 sec. to cancel sweep. • Pushing [SQL] also cancels sweep. 7 r Push [VFO] to return to normal operation. 8 9 [SQL] 1CLR SCOPE +DUP DTCS FM PRIO WX EMR A B 1 4 5 7 8 025 PSKIP µ 000 10 11 12 • The receive audio during sweeping can be muted in 13 sounds set mode. See p. 115 for details. 14 • We recommend setting the tuning step to less then 20 kHz when using band scope function. 15 • Even if a strong signal is present, it may not be displayed on the band scope if the tuning step is set to wide (ex.125 16 kHz, 200 kHz, etc) • The display frequency's audio sounds for single watch op- 17 eration within 118-174MHz and 350-470MHz regardless "Scope AF Output" setting in the MENU screen. 18 • If ghost waveform or audio appear, operate follow to avoid those. "tuning step changing," "selecting dualwatch," or 19 "changing non sweep frequency if dualwatch operating". 23